Skateboard bearings

Skateboard bearings are not as sophisticated as the yo-yos, because there are eight bearings and four middle locks on one plate, and the best eight replacement bearings are replaced, which is necessary regardless of which axis first explodes.

Bearing cleaning

The cleaning of the skateboard bearing is very simple. The bearing is removed from the plate, the oil stains and stains on the bearing are wiped off with a paper towel, and the inner wall of the wheel is also wiped off. It is beneficial to change the wheel on the left and right sides to change the bearing. It is probably cleaned once every week. When the plate is used, the high temperature generated by the rotation of the bearing will close the rubber of the wheel and the bearing wall, which is inconvenient when changing the wheel or changing the bearing. Therefore, the bearing should be removed from the wheel frequently. To avoid trouble, you can clean the bearings at the same time.

Bearing oil

Remember to oil after cleaning, the range of oil is very wide, edible oil can be, but some people say that the bought bearings are soaked in gasoline for a week, which is very wasteful of gasoline, bought back, it will be cleaned after one week. It’s okay to apply oil. The bearing that I just bought has lube oil. It is used to store the oil that prevents the bearing from rusting. When the board is used, the oil can be sent out of the bearing. When cleaning, the oil used for the first time is removed. Oil, these oils do not play a lubricating role, just like the measuring cylinder can not heat only the effect of measuring the liquid, only to prevent rust, but often used plate bearings are difficult to rust.

Bearing rust

When the bearing hits the water, it will rust. If it is going through the water, it will continue to slide. The water evaporation of the wheel will be very fast. After sliding about 10 meters, it will be evaporated.